/ / Fanuc Part Counter

Fanuc Part Counter

If your Fanuc controller is not properly reporting part counts to our Datanomix Monitoring system, then parameters #6700 and #6710 are what you want to check, in addition to what M-code is being used in the current program to tick the part counter. 

If #6700 is set to 0, it will count on M2, M30 or an M code specified in param #6710. 

If #6700 is set to 1, it will only count on the M code shown in param #6710. 

If your programs are not counting parts, and do not contain an M2 or M30, you may need to set #6710 to an M-code that can be used in your program at the appropriate location to cause the part counter to tick up. 

Similar Posts